| |
|
Specification:
1. Dimension : 14*26*73mm
2. Weight 45g (a battery and an antenna are not included)
3. The exclusive receiver for scramble transmitter
4. Synchronous frequency 398.605MHz, 399.030MHz,
399.455MHz, 399.885MHz
5. Voice output 100mW (32 ohms or more of external speaker
impedance)
6. Power supply voltage 3V (U 5x2)
7. Consumption current About 11mA (VOL 0) Use time About 60
hours (alkali dry cell)
8. Antenna 50ohms RCA jack A helical or 1/4 wave form memory
strait wire (17cm)
Summary:
．It is the exclusive receiver(TKS-151.A) of a scramble transmitter
(TKS-120.A).
．It restores to a receiver on the career of a transmitter in the form
which carries out an automatic tailing synchronization. The
click sound at the time of a synchronous change rate is slightly
mixed with receiving sound.
．It cannot be heard that it is not the receiver which became the
transmitter and the pair by the difference in the order of a
repetition of a career. There are six kinds of kinds of system.
．Troublesome operation is not required at all. It is receivable if a
power supply switch is put in.
Directions
．If the battery lid on the back of a rear is slid back, a battery
appears. It warns against making a mistake in polarity. Dry cell
of 5 is used two If an alkali dry cell is used, it can use further
for
a long time.
．An attached helical antenna is put in the antenna terminal of
the front of a main part. Subsequently, the side Knob of a small
slide switch written to be ON and OFF It moves in the direction
of ON. It will be in a state receivable now. Subsequently, a front
volume regulation knob (VOL) is turned until it becomes suitable
volume.
．It is heard using an earphone.
．When carrying out automatic recording, it is used by putting an
attached recording code in the earphone terminal of a receiver,
and the external microphone terminal of a recorder. The position
of the volume in this case is carried out to the position which
hears it by the earphone and can be heard ordinarily. A receiver,
a recorder, and cases are put together and it is made not to
install. When used by sticking, should carry out, insulate and
install paper, a cloth piece, etc. in between. Unless cases are
insulated, it may not be recorded normally.
Notes:
．When not receiving, the switch of a battery is surely cut. When
you do not use for a long period of time, please take out a
battery and place it. Internal parts are damaged when a battery
carries out a liquid leak.
．Since the inside consists of precision parts, please do not drop
it, or do not apply power which is twisted strongly. It carries out
as carefully as possible, the desorption of an antenna also
having both sides for a root portion with a finger, and turning to
right and left little by little slowly.
．Please do not attach a powerful magnet to a main part. It stops
functioning at an instant like a magnetic card. It does not return,
unless it readjusts.
|
